Knock sensor

Make it go fast! Kick it up a notch. Post tips in here.
ORFORD2004
Posts: 1099
Joined: Wed Mar 17, 2010 9:48 pm
Your car is a: 1983 PININFARINA
Location: Sherbrooke, Qc, Canada

Knock sensor

Postby ORFORD2004 » Wed Aug 09, 2017 9:41 pm

I will install a knock sensor in my car. I found 2 possible location. The first one is on the fuel pump cover but it's a bit far from the cylinders. The other one is using the coolant bolt on the exhaust side. Both are in the center of the engine and the fuel pump cover seems to be higher than the coolant bolt. Lot of heat on the coolant bolt side since it's under my turbo manifold. What do you think?

John

rridge
Posts: 161
Joined: Thu Aug 10, 2006 11:59 am
Your car is a: 1981 Turbo Spider

Re: Knock sensor

Postby rridge » Thu Aug 10, 2017 12:59 pm

For what its worth, the turbo conversion folks at Flying Miata recommends mounting the sensor on one of the engine mount bolts on the early Miata's with cast iron blocks and aluminum heads.

burgandy81
Posts: 371
Joined: Fri Feb 22, 2008 5:38 pm
Your car is a: 1981 FIAT Spider 2000
Location: Victoria, BC

Re: Knock sensor

Postby burgandy81 » Fri Aug 11, 2017 12:11 am

Hi John,

Wherever the 8V Integrale knock sensor is would be a good spot.

I tried a quick web search and did not see it. Maybe you can find an online manual?

Best,

Jordan

ORFORD2004
Posts: 1099
Joined: Wed Mar 17, 2010 9:48 pm
Your car is a: 1983 PININFARINA
Location: Sherbrooke, Qc, Canada

Re: Knock sensor

Postby ORFORD2004 » Fri Aug 11, 2017 6:41 pm

I suspect too much noise in the head and the coolant bolt is too big. I check the mounting position on my 83 block and I decide to put it on the fuel pump cover. But the engine in my car is from a 79 don't have the hole for the mechanical fuel pump. So I will have to drill in the casting a bit of center from the bolt that usually hold the cover.


Return to “Performance”

Who is online

Users browsing this forum: No registered users and 30 guests