Installed a set of FI "274" cams from Mark a while ago but could not get them degree'd in as the fellow that was going to do it picked up a long haul job. He quit and now had some time to allow me to help him get the fiat dialed in. The car I thought went well and the performance improvement was noticable. Yesterday we pulled the hood and rad and got the wheel on the crank and after a couple of hours the cams were dialed in with a 109 deg centerline. Took it out around the block a bit and what an improvement

The car pulls like nobodys buisness and with the new koni's and 1" front sway bar the car is a gas to drive. Woke up this am to a skiff of snow

hopefully this week sometime the roads are clear to play a bit more before the plates expire. Just a recomendation if anyone gets an upgraded set of cams, get them degree'd in properly.... I believe you will notice the difference. (need the adjustable cam wheels as well)
Now off to go x-country skiing
Chris